![]() Without that it would be slowed down by trying to perform reverse DNS on link-local addresses, which is not going to work anyway. The -n flag means no reverse DNS will be performed. The simplest way to ping all the hosts on a LAN is with IPv6: ping6 -nc2 ff02::1%eth0 Here is the ubuntu manual to use fping with different options. The network and broadcast addresses will be excluded. Specify the netmask or start/end in the targets Generate a target list from a supplied IP netmask, or a startingĪnd ending IP. Pinging a target will be made, not including the first try. This is the number of times an attempt at Nmap done: 256 IP addresses (12 hosts up) scanned in 4.46 secondsįping is another command to ping all ip in LAN. Nmap scan report for android (10.0.0.196) Nmap scan report for android (10.0.0.188) Nmap scan report for android (10.0.0.181) ![]() Nmap scan report for android (10.0.0.148) Nmap scan report for terrance-ubuntu (10.0.0.100) You can scan other IP address ranges like 192.168.0.1 - 192.168.1.254 by typing in the following: nmap -sP 192.168.0.1/23Ī typical scan might return something like the following: nmap -sP 10.0.0.1/24 The above command will scan all IP addresses starting at 192.168.1.1 through 192.168.1.254 and show you all IPs that responded. Then you can check your entire network for all connected IP addresses by typing in the following: nmap -sP 192.168.1.1/24 You can install an application called nmap. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |